Purchase Replacement Keyless Entry Remote Transmitter (complete Remote) This set is programming Instructions is used on newer Toyota models. Programming Instructions for your Keyless Entry Remote: Step 1: Start with your key out of the ignition, the driver's door open, and all other doors closed. Step 2: Within 5 seconds insert and remove your key from the ignition twice. Step 3: Perform the following within 40 seconds. Close and open the driver's door twice, then insert and remove your key from the ignition. Step 4: Perform the following within 40 seconds. Close then open the driver's door twice, then insert and remove the key from the ignition. Close the driver's door. Insert your key into the ignition and turn it to the "On" position, then back to the "Off" position and remove your key form the ignition. Step 5: Within 3 seconds the locks should cycle confirming the vehicle has entered programming mode. If the locks do not cycle restart from step 1. Step 6: Perform the following within 40 seconds. Press either of the switches (Lock or Unlock) on the door control transmitter for more than 1 second. Repeat step 6 for each new and existing remote. Step 7: To exit programming mode open the driver's door. Your Keyless Entry Remote is now programmed!